Materials – Cautions for Use
757
Removing dirt on the image sensor
The image sensor is very precise and delicate, so be sure to observe the
following when you do have to clean it yourself.
•
Blow dust off the surface of the image sensor using a commercially available blower.
Do not blow the dust off with excessive power.
• Do not put the blower further inside than the lens mount.
The blower can scratch the image sensor if it touches.
• Do not use any objects except a blower brush to clean the image sensor.
• If you cannot remove the dirt or dust with the blower, consult the dealer or
Panasonic.
Cleaning the Viewfinder
If the viewfinder becomes dirty, blow dirt off the surface of the viewfinder
using a commercially available blower, then lightly wipe with a soft dry
cloth.
•
The eye cup cannot be removed, so make sure it does not come loose when
cleaning the viewfinder.
• If the eye cup accidentally gets removed, consult the dealer or Panasonic.
Monitor/Viewfinder
• Do not push hard on the monitor.
This may cause irregular coloration or malfunction.
• Extremely high precision technology is employed to produce the monitor/viewfinder
screen. However there may be some dark or bright spots, or spots that light
constantly (red, blue, or green) on the screen.
This is not a malfunction.
Though the monitor/viewfinder screen parts are produced with highly controlled
precision technology, some pixels may be inactive or always lit.
The spots will not be recorded on images on a card.
To Next Page
Loading...
Need help?
General
