Panasonic NV-RX37A - Page 20

remaining tape time, the tape length of the cassette
being used must be set correctly on the Movie Camera
<-M9)
•When recording or playback starts, the Tape Length
Indication disappears, and in its place the [R]
Indication flashes while the remaining tape time is
being calculated. A few seconds later, the Remaining
Tape Time Indication appears. ({R] means Remaining.)
•When the remaining tape time is less than 2 minutes,
the [R] Indication and the Remaining Tape Time
Indication start to flash.
When you use a cassette bearing the [P] mark © or
other special types of cassettes, the Remaining Tape
Time Indication may not be very precise.
■ Preventing Accidental Erasure of
Recordings
• Recording on a previously recorded cassette erases
the existing scenes and sound.
•To protect important recordings against accidental
erasure, use a screwdriver to break out the tab © on
the cassette (some cassettes have sliding-type tabs).
•To be able to record again on a protected cassette,
firmly cover the hole where the tab was with two
layers of adhesive tape ©,
20