Panasonic PT-TX430 - [Security]

ENGLISH - 67
Note
f If you want to correct the digit, press as to reset the digit and then press as re-enter it.
f Press the <ENTER> button after moving the cursor to [Cancel] to return the menu screen.
f If you entered an incorrect digit, the digit () will turn red and reset, and then re-enter a digit.
[Security]
Set the PIN code to prevent the unauthorized operation by the third party. The [PIN code] input screen will be displayed when
turn on the projector.
1) Press as to select [Security].
2) Press the <ENTER> button.
f The [Security] screen is displayed.
3) Press as to switch the item.
f The items will switch each time you press the button.
[PIN code lock]
Prevent the projector from being operated by any third party by setting a PIN code.
[PIN code change]
Change the PIN code.
Attention
f The initial PIN code is "111".
f Change the PIN code periodically that is hard to guess.
f To return the PIN code to the factory default setting, please consult your dealer.
[PIN code lock]
Prevent the projector from being operated by any third party by setting a three-digit PIN code.
1) Press as to select [Security].
2) Press the <ENTER> button.
f The [Security] screen is displayed.
3) Press as to select [PIN code lock].
4) Press the <ENTER> button.
f The [PIN code] input screen is displayed.
5) Press the <ENTER> button.
6) Enter the PIN code you have set according to the steps in "Enter a PIN code".
f To set the PIN code for the rst time, you can enter a number (three-digit number) you want to set according to the
steps in “Enter a PIN code”.
r Enter a PIN code
i) Press as to select a number from 0 to 9.
ii) Press the <ENTER> button.
f The xed number change to , the cursor move to the next digit.
iii) Repeat the above steps, and enter a three-digit number.
f Move the cursor to [Set] after xing the three-digit number.
iv) Press the <ENTER> button.
f Return to the [Security] screen.
7) Press as to switch the item.
f The items will switch each time you press the button.
[On]
The [PIN code] screen will be displayed when the projector is turned on. The projector cannot be
operated without entering the PIN code.
[Off]
The projector can be operated without the PIN code.
Note
f If you want to correct the digit, press the <MENU> button to reset the digit and then re-enter it.
f Press the <ENTER> button after moving the cursor to [Cancel] to return the menu screen.
f If you entered an incorrect digit, the digit () will turn red and reset, and then re-enter a digit.
Chapter 4 Settings - [Expand] menu