Panasonic PT-TX430 - When Connecting Via Wireless LAN

ENGLISH - 81
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f When connecting cables to both the <HDMI IN> terminal and the <USB B (DISPLAY)> terminal, it may be difcult to remove
the LAN cable which is connected to the <LAN> terminal. When removing the LAN cable from the <LAN> terminal, remove a
cable connected to the <HDMI IN> terminal or the <USB B (DISPLAY)> terminal beforehand.
Note
f A LAN cable is required to use the wired LAN function.
f Use shielded LAN cable (STP cable) that is compatible with category 5 or above.
f Use a LAN cable with length of 100 m or shorter.
Projector settings
1) Use the LAN cable (Straight) to connect the projector with computer.
2) Turn on the projector.
3) Set the [Expand] menu → [Network] → [Network setting].
f For details, refer to the [Expand] menu → [Network] (x page 70).
Note
f Please conrm with your network administrator before you connect to an existing network.
f The wired LAN and wireless LAN cannot be used in the same segment.
f The following is preset as the factory default setting.
[DHCP]
Off
[IP address]
192.168.1.100
[Subnet]
255.255.255.0
[Gateway]
192.168.1.1
[DNS]
192.168.1.1
Computer setting
1) Turn on the computer.
2) Make the network setting according to your system administrator.
f If the projector settings are the default settings, the computer can be used with the following network settings.
[IP address]
192.168.1.101
[Subnet]
255.255.255.0
[Gateway]
192.168.1.1
When connecting via wireless LAN
The wireless module (Model No.: ET-WML100) of the optional accessories is required if you want to use the network function
through the wireless LAN.
f Only one projector can be connected with the wireless LAN.
Connection example
IEEE802.11b/g/n
Wireless module of optional accessories
(Model No.: ET-WML100)
Preparation and conrmation of the projector
1) Turn on the projector.
2) Attach the wireless module (Model No.: ET-WML100) of optional accessories firmly into the <USB A
(VIEWER/WIRELESS)> terminal.
Chapter 5 Operation of Function - Network connection