Panasonic PT-TX430

ENGLISH - 71
[Network information]
1) Press as to select [Network].
2) Press the <ENTER> button.
f The [Network] screen is displayed and then conrm the following items.
[MAC address]
Displays the MAC address of this projector.
[IP address]
Displays the current IP address of this projector.
[SSID] *
1
Displays the SSID character string of the projector while the Wireless LAN is connected.
[Wireless IP] *
1
Displays the IP address of the wireless module which is inserted into the projector while the
wireless LAN is connected.
*1 It will be displayed when the wireless module (Model No.: ET-WML100) of the optional accessories is inserted.
[Remote control]
This switching function prevents remote control interference when operating several projectors or video equipment at the same
time.
1) Press as to select [Remote control].
2) Press the <ENTER> button.
f The [Remote control] screen is displayed.
3) Press as to select one item.
f This projector provides seven different remote control codes: [ALL], [Code 1]~[Code 6].
[ALL]
Select when controlling projectors without specifying an ID number.
[Code 1] - [Code 6]
Select when specifying an ID number to control individual projector.
4) Press the <ENTER> button.
f [Remote control] is set.
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specied by remote control. If
multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors with
other ID numbers.
f Refer to "Setting the remote control ID numbers" (x page 44) for how to set the ID number on the remote control.
[Factory default]
Return various setting values to their factory default settings.
1) Press as to select [Factory default].
2) Press the <ENTER> button.
f The [Return to Factory default?] screen is displayed.
3) Press as to select [Yes] and then press the <ENTER> button.
f The [OK?] screen is displayed.
4) Press as to select [Yes] and then press the <ENTER> button.
f The [Please wait] message will appear, and resetting operation will start, and after completing the operation, the
[Please wait] message will disappear.
Attention
f After executing the [Factory default], be sure to turn off the projector (x page 36), disconnect the power plug from the wall
outlet, and then turn on the projector in order to reect the initial setting values.
Note
f The PIN code, logo PIN code, [Logo select] setting, user logo, lamp usage time and lter usage time will not return to the
factory default settings even if [Factory default] is executed.
Chapter 4 Settings - [Expand] menu