Panasonic PT-TX430

ENGLISH - 69
11) Press as to switch the setting time of [Ready Countdown].
f The items will switch each time you press the button.
f The waiting time before the projector switches from the ready state to the standby state can be set from 1 minute to 30
minutes in increments of 1 minute.
f When set to [0 Min], the projector will stay at the ready state instead of entering standby state.
[Filter counter]
Check the usage time of the air lter and set the cleaning cycle of the air lter. Also, the usage time of the air lter can be reset.
1) Press as to select [Filter counter].
2) Press the <ENTER> button.
f The [Filter counter] screen is displayed.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Filter counter]
Displays the usage time of the lter.
[Timer]
Sets the cleaning cycle of the lter.
[Filter counter
reset]
Resets the usage time of the lter.
Setting [Timer]
If you want to clean the air lter periodically, set the cycle time. Once the usage time of the lter reaches the set time, the lter
warning icon [ ] is displayed on the projected screen.
1) Press as to select [Filter counter].
2) Press the <ENTER> button.
f The [Filter counter] screen is displayed.
3) Press as to select [Timer].
4) Press the <ENTER> button.
5) Press as to switch the setting of the time.
f The items will switch each time you press the button.
[Off] → [100 H] → [200 H] → [300 H]
f The lter warning icon [ ] will not be displayed if [Timer] is set to [Off].
[Filter counter reset]
1) Press as to select [Filter counter].
2) Press the <ENTER> button.
f The [Filter counter] screen is displayed.
3) Press as to select [Filter counter reset].
4) Press the <ENTER> button.
f The [Filter counter Reset?] screen is displayed.
5) Press as to select [Yes] and then press the <ENTER> button.
f The [OK?] screen is displayed.
6) Press as to select [Yes] and then press the <ENTER> button.
[Test pattern]
Displays the Test pattern built-in to the projector.
Settings of position, size, and other factors will not be reected in test patterns. Make sure to display the input signal before
performing various adjustments.
1) Press as to select [Test pattern].
2) Press the <ENTER> button.
f The [Test pattern] screen is displayed.
3) Press as to switch the item.
Chapter 4 Settings - [Expand] menu