ENGLISH - 91
Power/Warning Indicators
If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f Before you take a remedial measure, follow the procedure of switching the power off indicated in “Powering Off the
Projector” (x page 36).
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Power indicator
<ON(G)/STANDBY(R)>
Warning
indicator
<WARNING>
Status Cause Solution
Off Off
The power plug is not
connected to the outlet.
--
Connect the power plug
to an outlet.
Red
Blinking Lighting in red
It has reached the replace-
ment time of the lamp unit.
f The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f Replace the lamp
unit.
Blinking Blinking in red
It has exceeded the re-
placement time of the lamp
unit and the projector is
turned off automatically.
f The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
Green
Lighting Lighting in red
The replacement time of
the lamp unit is displayed.
(Projecting)
f Is the lamp
replacement warning
icon
displayed when turn
on or turn off the
projector?
f The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f Replace the lamp
unit.
Lighting Blinking in red
It has exceeded the re-
placement time of the lamp
unit and the projector is
turned off automatically.
f The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
Blinking Off
The power cord is plugged
and the lamp is turned off.
(Ready state)
f [Power management] is set to [Ready].
If a video signal is input in Ready mode, or when
you press any button other than the power
<v/b> button, the luminous lamp turns on
and the projector enters the projection state.
Pressing the power <v/b> button during
the Ready state will enter the standby state.
(x page 68)
Chapter 6 Maintenance - Power/Warning Indicators
To Next Page
Loading...
