Row 3 Connectors
AUX SEND 1/2
Use RCA connectors to attach a digital effects device or another S/PDIF device
to the AUX SEND 1/2 and AUX RETURN 1/2 digital terminals. AUX/BUS
Fader Layer faders control the AUX 1/2 SEND and RETURN. These
connections are not analog signals.
AUX SEND 3/4, 5/6
These terminals are 1/4” TRS phone plug connectors, at a level of +4dB,
10kΩ UNBAL. They can be used for connecting outboard signal processing
devices, or for a studio headphone feed, or as part of a multitrack output
setup. The possibilities are limited only by your imagination. The AUX/BUS
Fader Layer is the fader control for these connections. Detailed cable
connections are shown in Appendix E, Cables and Connections.
AUX RETURN 3/4, 5/6
These terminals are 1/4” TRS phone plug connectors, at a level of +4dB,
10kΩ UNBAL. The AUX/BUS Fader Layer is the fader control for these
feeds. See Appendix E, Cables and Connections for more information.
2-Track B Input
This is used to connect an analog source strictly for monitoring purposes, as
it does not appear as an input to the mixer. Connect a 1/4” TRS phone plug
to the output signal from a cassette deck, for example. The input signals are
sent to the 2 TR B IN LED button in the monitor section. The level is +4dB,
10kΩ BAL.
Monitor A Out
These terminals are 1/4” TRS dual phone plugs at a level of +4dB, 600Ω BAL,
and connect the output of the MONITOR A source selection to an external
amplifier (or powered speaker) for monitoring in the control room (CR).
Chapter 2
DA7 Users’ Guide
2
-
27
2
DA7 Tour
Master L/R outputs
(Analog XLR balanced)
Record L/R outputs
(Analog TRS balanced)
Monitor B outputs
(Analog TRS balanced)
Monitor A outputs
(Analog TRS balanced)
2TR B input connectors
(Analog TRS balanced)
Aux Returns
3/4 and 5/6
(Analog TRS)
Aux Sends 3/4 and
5/6 (Analog TRS)
Aux 1/2 send and
return (Digital
RCA, S/PDIF)
Cutaway of DA7 Rear Panel (Row 3) Output Connectors
To Next Page
Loading...
