Parker 650V series - Page 32

Installing the Drive 3-15
650V AC Drive
Power Wiring Connections (Frame E)
brake
resistor
3PH
PE L1
L2 L3
M
Brake resistor and cable must be screened
if not fitted inside a control cubicle
PE1
DBR+ DBR-L1 L2 L3 DC+ DC- M1/U M2/V M3/W
motor
thermistor
MOT/
TEMP
All screens terminated using a gland at the gland plate
Note: The standard Frame E terminals are not intended for flat busbar. A Power Terminal
adaptor is available to enable wiring with flat busbar, part number BE465483.
1. Remove the terminal cover retaining screws and lift off the terminal cover.
2. Feed the power supply and motor cables into the drive through the metal gland plate using
the correct cable entries, and connect to the power terminals. Tighten all terminals to the
correct tightening torque, refer to the Terminal Tightening Torques table.
Power Wiring Connections (Frame F)
brake
resistor
3PH
PE L1
L2 L3
M
PE1
DBR+ DBR-
L1 L2 L3 DC+ DC- M1/U M2/V M3/W
All screens terminated using a gland at the gland plate
auxiliary
supply
motor thermistor
MOT/
TEMP
(on control board
support bracket)
(fan)
Note: The standard Frame F terminals are not intended for flat busbar. A Power Terminal
adaptor is available to enable wiring with flat busbar, part number BE465483.
1. Remove the terminal cover retaining screws and lift off the terminal cover.
2. Feed the power supply and motor cables into the drive through the metal gland plate using
the correct cable entries, and connect to the power terminals. Tighten all terminals to the
correct tightening torque, refer to the Terminal Tightening Torques table.
IMPORTANT: Remember to provide the auxiliary supply for the Frame F cooling fan. In Chapter 9,
check for the correct voltage via the Product Code, and refer to Cooling Fans for correct
wiring.