SINGLE Sampling Mode
HandiLaz Mini Operator’s Manual
Page
3-3
SINGLE Sampling Mode
Use this sampling mode when taking only one sample.
To open the SINGLE sampling mode:
1
Use either arrow key to navigate to MEASURE MODE on the main menu.
2
Press the
ENTER
key.
The MEASURE MODE menu will open.
3
Use either arrow key to navigate to SINGLE.
4
Press the
ENTER
key.
The SINGLE measure mode setup screen will open.
Setting SINGLE Sample Parameters
The parameters seen when the SINGLE measure mode is opened are those that
were saved when the repeat mode was last run. The SINGLE measuring mode
can be run as it is, without changing any sample parameters.
To edit the setup screen:
1
Press the
ENTER
key.
Pressing the
ENTER
key moves the cursor in a loop through each field that can
be edited.
2
At the field to be changed, press the up ▲ or down ▼ key.
The field setting will loop through its range of allowable settings.
To close the edit function and run the sample:
1
Use the
ENTER
key to navigate to NO at the lower-right corner of the display.
2
Use the up ▲ or down ▼ key to toggle the NO to OK.
3
Press the
ENTER
key.
The SAMPLING display will appear.
SINGLE 0.3/0.5/5.0µm
LOC.023 STR:N BEEP:N
SAMPLE 00:15
FREE REC.:09950 NO
SAMPLING
SAMPLE TIME 00:00:45
TOTAL TIME 00:01:15
FREE REC.:09500 OK
To Next Page
Loading...
Need help?
General
