HandiLaz Mini Operator’s Manual Page A-1
Appendix A
Menu Tree
<MENU>
MEASURE MODE
DATA PROCESSING
OPTIONS
<MEASURE MODE> (Sampling Mode)
REPEAT (Take multiple samples)
SINGLE (Take one sample)
CONT (Sample Continuously until press STOP)
CALC (Take samples, make calculations)
REMOTE ***NOT SUPPORTED***
ISO (Take samples, perform ISO calculations)
<ISO END> (Completed sampling at this location)
NEXT POINT? (Start sampling at next location)
ERASE DATA? (Erase data from this location)
CALCULATE? (Calculate mean, etc. for locations sampled)
EDIT TIMES? (Edit # samples at next location)
FINISH? (Make final calculations; Save if STR=YES)
<DATA PROCESSING>
DISPLAY (Review stored data records)
UPLINK (Dedicate unit to communication with PC)
PRINT (Print designated records on external printer)
CLEAR (Erase memory)
<OPTIONS>
ALARM (Set alarm values for 0.3, 0.5, or 5.0 µm channels)
UNITS (CNT, /cf, or m3)
UTILITIES
HOTKEY
AUTOST (AUTOSTART)
<UTILITIES>
DATE (yyyy/mm/dd)
TIME
ID (0-31)
COMMUNICATION (RS232C, RS485)
<AUTOSTART>
DELAY (10-99 SEC)
AUTOSTART (ON, OFF)
To Next Page
Loading...
