CALC (Calculation) Mode
HandiLaz Mini Operator’s Manual
Page
3-5
To close the edit function and run the sample:
1
Use the
ENTER
key to navigate to NO.
2
Use the up or down key to toggle the NO to OK.
3
Press the
ENTER
key.
The SAMPLING display will appear.
Taking CONT (Continuous) Sample
Press the
ENTER
key. After the initial delay, press
STOP/START
to begin sampling.
Sampling continues until the operator stops it.
CALC (Calculation) Mode
Use this sampling mode to have the HandiLaz Mini take the preset number of
samples, calculate the Average, Standard Deviation, Minimum, and Maximum
values for each size channel.
To open the CALC sampling mode:
1
Use either arrow key (▲ or ▼) to navigate to 1.MEASURE MODE on the main
menu.
2
Press the
ENTER
key.
The MEASURE MODE menu will open.
3
Use either arrow key to navigate to 4.CALC.
4
Press the
ENTER
key.
The CALC measure mode setup screen will open.
SAMPLING
SAMPLE TIME 00:00:45
TOTAL TIME 00:01:15
FREE REC.:09500 OK
CALC 0.3/0.5/5.0µm
LOC.023 STR:N BEEP:N
SAMPLE 00:15 3TIMES
FREE REC.:09500 NO
To Next Page
Loading...
Need help?
General
