Page 4-4 HandiLaz Mini Operator’s Manual
Chapter 4: DATA PROCESSING Settings
PRINT
This function prints one or more of the data records on the optional external
printer. The user can choose to print the following:
• All records
• A range of records—the user selects the first and last record to be printed. All
intermediate records will also be printed.
• A single record
NOTE:
If the printer has not been used before, its mode settings and serial
settings must be configured. See Chapter C, "Printer Setup".
To print from the HandiLaz Mini:
1
Connect the printer cable from the HandiLaz Mini to the printer.
2
Ensure that HandiLaz Mini communications setting is RS232C.
3
From the main MENU select DATA PROCESSING and press the
ENTER
key.
4
In the <DATA PROCESSING> menu, navigate to PRINT and press the
ENTER
key.
The following display will appear:
Example – Print records 2, 3, and 4:
1
From the <PRINT> display seen above, press the
ENTER
key until the cursor is
over the 1.
2
Use the down ▼ key to change the 1 to 2.
3
Press the
ENTER
key again, until the cursor moves over the 6.
4
Press the down ▼ key until the 6 changes to 4.
The <PRINT> function is now set to print records 2 through 4.
5
Press the
START
/
STOP
key. The printer will begin printing and stop when all
records in the range are printed.
<PRINT>
RECORDS 6
1.START 00001
2.END 00006
Total number of storage
spaces used
First record to be printed
Last record to be printed
To Next Page
Loading...
Need help?
General
