ISO Sampling Mode
HandiLaz Mini Operator’s Manual
Page
3-7
3
Use either arrow key to navigate to
ISO
.
4
Press the
ENTER
key.
The ISO sampling mode setup screen will open.
Setting ISO Sample Parameters
The parameters seen when the ISO measure mode is opened are those that were
saved when that mode was last run. The ISO measuring mode can be run as it
is, without changing any sample parameters.
To edit the setup screen:
1
Press the
ENTER
key to move the cursor in a loop through each field that can be
edited.
2
When the cursor is over the field to be changed, press the up ▲ or down ▼ key.
The field setting will loop through its range of allowable settings.
3
When the field is set correctly, press the
ENTER
key again to move to the next
field that can be edited.
To close the edit function and run the sample:
1
Use the
ENTER
key to navigate to
NO
at the lower-right corner of the display.
2
Use the up ▲ or down ▼ key to toggle the
NO
to
OK
.
3
Press the
ENTER
key.
The SAMPLING display will appear.
ISO 0.5/5.0µm
STR:N BEEP:N
SAMPLE 00:15 3TIMES
INT 00:00:15 OK
SAMPLING
SAMPLE TIME 00:00:45
TOTAL TIME 00:01:15
FREE REC.:09500 OK
To Next Page
Loading...
