Page B-2 HandiLaz Mini Operator’s Manual
Appendix B: Abbreviations and Definitions
FIN/FINISH Screen FINISHED sampling or subsampling
FREE REC. Screen Free space to store additional records
HOTKEY Screen Key that allows quick sampling start
IMPERF. TEST Screen Imperfect Test = Invalid sample
INT Screen Cycle INTERVAL =
a) Time to conduct subsample, plus
b) Delay before next subsample
ISO Screen, Printout ISO Mode: Used to certify that rooms meet
ISO standards
LOC Screen, Printout LOCATION where sampling being performed
N/NO Screen NO; Not ready to sample
NEXT POINT/ Iso Screen Start sampling at next location
OK Screen Ready to sample; All settings completed
POINT Screen LOCATION where sample/subsample taken
(0–255)
PTCL Screen PARTICLE Display Units: “/M^3”, “/Ft.^3”, or
CNT (i.e., Counts)
PREV Screen, Printout PREVIOUS screen
READY Screen Press START to begin sampling
REMOTE Screen, Printout NOTE: This mode is not supported
REPEAT Screen, Printout REPEAT Mode: Takes a series of identical
samples (as defined in sampling settings)
RUN Screen Sampling underway
SAMPLE mm:ss Screen Duration of single sample in minutes and
seconds
SAMPLETIME Screen Total time sampling at location.
SD Screen Standard Deviation
SINGLE Screen, Printout SINGLE Sample Mode: Takes a single sample
as defined in sampling settings)
START Screen First record to be Displayed or Printed
Term Where Found Meaning
To Next Page
Loading...
Need help?
General
