Particle Measuring Systems LASAIR II 550L Operator's Manual


Page Page 8-12 8-12 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Chapter 8: Statistics ModeChapter 8: Statistics Mode
Statistics mode disable-enable. SelectStatistics mode disable-enable. Select
OO
to disable theto disable the
statistics mode. Selectstatistics mode. Select ❙❙to enable the statistics mode. Once to enable the statistics mode. Once the statistics modethe statistics mode
is enabled, it will be maintained throughout power cycles until it is disabled inis enabled, it will be maintained throughout power cycles until it is disabled in
thethe StatistiStatistics cs SetupSetuporor Statistics ResultsStatistics Resultsscreen. Also, once the statistics mode isscreen. Also, once the statistics mode is
enabled, most parameters are locked out.enabled, most parameters are locked out.
This button saves the Statistics Setup as a recipe. See Chapter 9,This button saves the Statistics Setup as a recipe. See Chapter 9,
"Recipes"."Recipes".
Statistics Mode OperationStatistics Mode Operation
Once you have set up the Once you have set up the LASAIR II for sampling, operation is a simple matterLASAIR II for sampling, operation is a simple matter..
Use the following steps to operate the LASAIR II.Use the following steps to operate the LASAIR II.
Collecting Sample DataCollecting Sample Data
To collect sample data:To collect sample data:
11
After setting the variables for the statistics function and enabling the statisticsAfter setting the variables for the statistics function and enabling the statistics
mode, take the LASAIR II to the first sampling location.mode, take the LASAIR II to the first sampling location.
22
If you are using wall power, plug in the unit.If you are using wall power, plug in the unit.
33 If the LASAIR II is already plugged in, but If the LASAIR II is already plugged in, but the display is blank, press the ON/the display is blank, press the ON/
OFF button in the lower right of the OFF button in the lower right of the control panel. Ycontrol panel. You will hear a beep ou will hear a beep duringduring
the startup process.the startup process.
44 When theWhen theMain DisplayMain Displayis visible, ensure that the LASAIR II is in statisticsis visible, ensure that the LASAIR II is in statistics
mode. mode. The The statistics statistics mode mode icon icon will will be be visible visible on on the the main main displaydisplay..

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English