Page Page 5-22 5-22 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Chapter 5: SetupChapter 5: Setup
Communications Setup Screens (Comm Setup)Communications Setup Screens (Comm Setup)
To open the Comm Setup Screens:To open the Comm Setup Screens:
11 On On the the main main display display screen, screen, press press the the Main Main Setup Setup softkey softkey . . The The Main Main SetupSetup
Screen will be displayed.Screen will be displayed.
22
Press Press the the Comm Comm Setup Setup softkey softkey TheThe Comm Setup - Network ScreenComm Setup - Network Screenwillwill
open.open.
Notice thatNotice that Comm SetupComm Setupis comprised of the following three screens:is comprised of the following three screens:
•• the Nthe N
etworketwork
setup setup screen. Figurescreen. Figure 5-13, “Comm Setup 5-13, “Comm Setup Screen, NetworkScreen, Network
Page.Page.
•• thethe SerialSerial setup screen. setup screen. FigureFigure 5-14, “Comm 5-14, “Comm Setup Screen, SeriSetup Screen, Serial Page.al Page.
•• thethe
DataData
setup screen.setup screen.
The three screens are opened by The three screens are opened by sequentially pressing thesequentially pressing the Screen SelectScreen Select
softkey.softkey.
Comm Setup - Network PageComm Setup - Network Page
TheTheDataDatadisplay setup window is used to enable and display setup window is used to enable and disable the 0.5disable the 0.5µµand 5.0and 5.0µµ
data display mode. See Chapdata display mode. See Chapter H, "Pharmaceutical (Two-channel) Outputter H, "Pharmaceutical (Two-channel) Output
Mode".Mode".
This setup screen is also used for TouchRam configuration. See Chapter M,This setup screen is also used for TouchRam configuration. See Chapter M,
"TouchRam"."TouchRam".
Figure 5-13: Comm Setup Screen, Network PageFigure 5-13: Comm Setup Screen, Network Page
To Next Page
Loading...
Need help?
General
