Particle Measuring Systems LASAIR II 550L Operator's Manual


Sampling Setup ScreenSampling Setup Screen
LASAIR II Operator’s ManualLASAIR II Operator’s Manual
PagePage
5-55-5
TTo perform this sequenceo perform this sequence, the following settings must , the following settings must be made:be made:
If there were no set values for the initial and inter-sample delays, these pausesIf there were no set values for the initial and inter-sample delays, these pauses
will be performed in every cycle.will be performed in every cycle.
AutoPrintAutoPrint Select this icon to automatically print at the Select this icon to automatically print at the end of eachend of each
sample. When On, the Printer icon is visible. When Off, the icon is greyed out.sample. When On, the Printer icon is visible. When Off, the icon is greyed out.
NOTE:NOTE: The delay time between samplesThe delay time between samples plusplusthe sample time must be at leastthe sample time must be at least
15 seconds to allow enough 15 seconds to allow enough time for the printer to finish the last job.time for the printer to finish the last job.
Sample by TimeSample by Time
Enable this icon to sample byEnable this icon to sample by timetime..
NOTE:NOTE: Sampling is performed for either a designated time or a Sampling is performed for either a designated time or a designateddesignated
volume.volume.
SSaammpplle e ssiizze e == IInnffiinniittyy
= = EnabledEnabled
GGroroup up rerepepeat at == EnEnabableledd
AAuuttoopprriinnt t == EEnnaabblleedd
Figure 5-2: Sampling Setup Screen - AdvancedFigure 5-2: Sampling Setup Screen - Advanced

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English