Particle Measuring Systems LASAIR II 550L Operator's Manual


Page Page 8-16 8-16 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Chapter 8: Statistics ModeChapter 8: Statistics Mode
88
Move the LASAIR II to the next sampling location and continue sampling untilMove the LASAIR II to the next sampling location and continue sampling until
all locations are sampled or terminate sampling if you must.all locations are sampled or terminate sampling if you must.
Observing Statistical ResultsObserving Statistical Results
Sample results are displayed in theSample results are displayed in the Statistics SummaryStatistics Summaryscreen and thescreen and the StatisticsStatistics
TableTable
after each sample is completed.after each sample is completed.
StatStatistics Summary istics Summary ScreenScreen
TheThe Statistics SummaryStatistics Summaryscreen displays settings, progress, and the cumulativescreen displays settings, progress, and the cumulative
result of completed samples.result of completed samples.
The following data is displayed on the The following data is displayed on the Statistics Summary screen.Statistics Summary screen.
Figure 8-4: Statistics Summary ScreenFigure 8-4: Statistics Summary Screen
TTable 8-6: able 8-6: Statistics Summary Screen DataStatistics Summary Screen Data
DDaattaa DDeeffiinniittiioonn
ISO 14644/ISO 9ISO 14644/ISO 9 the name of the the name of the user-selected standard and classuser-selected standard and class
Name:Name:
the user-assigned name of the room that is the user-assigned name of the room that is being sampledbeing sampled
Sample locationsSample locations
completed, Totalcompleted, Total
number of locations,number of locations,
and Minimumand Minimum
number of locationsnumber of locations
Example: 5 locations have been completed. The total numberExample: 5 locations have been completed. The total number
of locations planned to be sampled was five. of locations planned to be sampled was five. The minimumThe minimum
number of locations requested is 5. If the BS-5295 standard isnumber of locations requested is 5. If the BS-5295 standard is
notnotbeing used, the user may being used, the user may set the total number of locationsset the total number of locations
to a number greater than to a number greater than the minimum.the minimum.

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English