Particle Measuring Systems LASAIR II 550L Operator's Manual


Using LASAIR II in Remote ModeUsing LASAIR II in Remote Mode
LASAIR II Operator’s ManualLASAIR II Operator’s Manual
PagePage
7-77-7
Setting the Communications Screen for 0.5 and 5.0Setting the Communications Screen for 0.5 and 5.0 µµmm
Output Only (2 Channel Pharmaceutical Output)Output Only (2 Channel Pharmaceutical Output)
The Communications Setup Screen (Data) may be set to cause output with 0.5The Communications Setup Screen (Data) may be set to cause output with 0.5
and 5.0and 5.0 µµm output only. See Appendix m output only. See Appendix H, "Pharmaceutical (Two-channel)H, "Pharmaceutical (Two-channel)
Output Mode".Output Mode".
Using LASAIR II in Remote ModeUsing LASAIR II in Remote Mode
“Remote mode” means that LASAIR II will not be permanently connected to“Remote mode” means that LASAIR II will not be permanently connected to
any other communications or control network while it is collecting data. Thatany other communications or control network while it is collecting data. That
is, it is used in a stand-alone mode is, it is used in a stand-alone mode to collect data from multiple locations.to collect data from multiple locations.
PeriodicallyPeriodically, the LASAIR II is connected to , the LASAIR II is connected to an Ethernet network to downloadan Ethernet network to download
its accumulated data to Facility Net. The downloaded data can its accumulated data to Facility Net. The downloaded data can then be stored inthen be stored in
a digital file which has few if any size limitations and which can be backed up.a digital file which has few if any size limitations and which can be backed up.
Also, the data will then be available to analytical and graphical software.Also, the data will then be available to analytical and graphical software.
Preparing LASAIR II for use in Remote Preparing LASAIR II for use in Remote ModeMode
Complete the following steps to ensure that your LASAIR II is ready for use inComplete the following steps to ensure that your LASAIR II is ready for use in
the Remote Mode.the Remote Mode.
NOTE:NOTE: Before using this feature, ensure that your version of Facility Net hasBefore using this feature, ensure that your version of Facility Net has
the required versions of the .dll and the required versions of the .dll and .hlp files listed on the following page. If.hlp files listed on the following page. If
these files are not correct, contact your local these files are not correct, contact your local Particle Measuring SystemsParticle Measuring Systems
representative.representative.
Figure 7-4: Comm Setup Screen, DataFigure 7-4: Comm Setup Screen, Data

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English