Particle Measuring Systems LASAIR II 550L Operator's Manual


Alarm Setup ScreenAlarm Setup Screen
LASAIR II Operator’s ManualLASAIR II Operator’s Manual
PagePage
5-115-11
the following actions:the following actions:
aa)) AAddd d nneew w nnaammees s iinnsstteeaad d oof f eeddiittiinng g oolld d nnaammeess..
b)b) Erase the stored data before changing any location names.Erase the stored data before changing any location names.
33
Using the editing softkeys and directional arrow buttons on the Using the editing softkeys and directional arrow buttons on the control panel,control panel,
edit the name. Pressing the edit the name. Pressing the Right or Left Arrows moves the cursor. Pressing theRight or Left Arrows moves the cursor. Pressing the
Up or Down Arrows change the alphanumeric value.Up or Down Arrows change the alphanumeric value.
44
When editing is complete, press the Enter button on When editing is complete, press the Enter button on the control panel tothe control panel to
highlight thehighlight the
OKOK
button.button.
55
Press the Enter button again to save the Press the Enter button again to save the edited location name.edited location name.
To delete a location name:To delete a location name:
11
In the Location Name Setup screen, use the Up aIn the Location Name Setup screen, use the Up and Down Arrow buttons on thend Down Arrow buttons on the
control panel to highlight the location name to be deleted.control panel to highlight the location name to be deleted.
22
Press Press the the Delete Delete Location Location softkey softkey . . The The highlighted highlighted location location name name will will bebe
deleted from the list.deleted from the list.
Alarm Setup ScreenAlarm Setup Screen
The Alarm Setup Screen allows you to set an alarm for maximum paThe Alarm Setup Screen allows you to set an alarm for maximum particle count,rticle count,
as well as minimum or maximum analog values. After you as well as minimum or maximum analog values. After you set an alarm, theset an alarm, the
LASAIR II display flashes red and yellow when the LASAIR II display flashes red and yellow when the defined limit has beendefined limit has been
exceeded. You can also set an audio alarm.exceeded. You can also set an audio alarm.
Silencing AlarmsSilencing Alarms
If the alarm is activated, the Main Display Screen If the alarm is activated, the Main Display Screen (and Analog Data Display(and Analog Data Display
Screen) will blink red and Screen) will blink red and yellowyellow. If the audio . If the audio alarm has been set, alarm has been set, the unit willthe unit will
beep.beep.
To silence an alarm:To silence an alarm:
Press the Enter button until all alarms are off. The triggering value will remainPress the Enter button until all alarms are off. The triggering value will remain
in red on the Main in red on the Main Display Screen if it is a particle alarm (or Display Screen if it is a particle alarm (or on the Analog Dataon the Analog Data
Display Screen, if it is an analog vaDisplay Screen, if it is an analog value).lue).
To stop the red and yellow flashing:To stop the red and yellow flashing:
After the pump stops, press the Enter button once After the pump stops, press the Enter button once more (after pressing it tomore (after pressing it to
silence the alarm). Ysilence the alarm). You can also silence alarms and ou can also silence alarms and stop the red and yellowstop the red and yellow
blinking by repeating the sampling, without exceeding an alarm limit, or byblinking by repeating the sampling, without exceeding an alarm limit, or by
turning the unit OFF and then ON.turning the unit OFF and then ON.

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English