Particle Measuring Systems LASAIR II 550L Operator's Manual


Page Page 2-2 2-2 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Chapter 2: Unpacking and InstallationChapter 2: Unpacking and Installation
If all of the materials are included and undamaged, store the If all of the materials are included and undamaged, store the packing materials.packing materials.
It is important to store these materials because warranties may not apply ifIt is important to store these materials because warranties may not apply if
return shipping containers are inadequate.return shipping containers are inadequate.
Installing the LASAIR IIInstalling the LASAIR II
Use the following installation sections as they apply to your use of the LASAIRUse the following installation sections as they apply to your use of the LASAIR
II.II.
Connecting YConnecting Your Power our Power SourceSource
The power input is a The power input is a standard EIA fused power standard EIA fused power input of 100–240 Vinput of 100–240 VAC, 50–60AC, 50–60
Hz. A power cord is supplied with youHz. A power cord is supplied with your LASAIR II. The power cord forr LASAIR II. The power cord for
European shipments may require the attachment of the European shipments may require the attachment of the appropriate wall plug,appropriate wall plug,
according to the electrical requirements.according to the electrical requirements.
Ensure the main supply is properlyEnsure the main supply is properly
grounded!grounded!
To connect power for the LASAIR II:To connect power for the LASAIR II:
11
Plug the female end of the Plug the female end of the cord into the power inlet. The inlet is locacord into the power inlet. The inlet is located on theted on the
left side of the back panel.left side of the back panel.
22
Plug the 3-prong end of the cord into your power source.Plug the 3-prong end of the cord into your power source.
NOTE:NOTE: The main power disconnect The main power disconnect is the power cord. Ensure that is the power cord. Ensure that it is easilyit is easily
accessible!accessible!
Installing the Battery PackInstalling the Battery Pack
YYour LASAIR II can be poour LASAIR II can be powered solely by an optional rechargeable bawered solely by an optional rechargeable batteryttery
pack. The battery pack can be pack. The battery pack can be charged while it charged while it is installed iis installed in the LASAIR II n the LASAIR II oror
outside the LASAIR II outside the LASAIR II with its optional BC II with its optional BC II battery charger.battery charger.
To install the battery pack:To install the battery pack:
11 Remove the battery from its packaging.Remove the battery from its packaging.
22 Position the battery pack with the label up and write the date you are placing thePosition the battery pack with the label up and write the date you are placing the
battery into service into the space provided on the label.battery into service into the space provided on the label.
33
Open the battery chamber door on the back of the LASAIR IIOpen the battery chamber door on the back of the LASAIR II
CAUTIONCAUTION
Particle Measuring Systems recommends the use of a good Particle Measuring Systems recommends the use of a good quality surgequality surge
protector to isolate the LASAIR II from voltprotector to isolate the LASAIR II from voltage spikes. Surge protectors areage spikes. Surge protectors are
inexpensive and easily obtainable from many inexpensive and easily obtainable from many office supply or computeroffice supply or computer
equipment sources.equipment sources.

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English