Page Page H-2 H-2 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Appendix H: Pharmaceutical (two-channel) Output ModeAppendix H: Pharmaceutical (two-channel) Output Mode
33
Enable the edit mode and place a check mark in theEnable the edit mode and place a check mark in theEnable TCP/IPEnable TCP/IPcheck box.check box.
44 Click on theClick on the Screen SelectScreen Selecticon icon softkey softkey until until thethe Comm Setup-DataComm Setup-Data dialogdialog
box opens.box opens.
To allow only 2-channel data to be output to Pharmaceutical Net:To allow only 2-channel data to be output to Pharmaceutical Net:
11 Press thePress theEnterEnterkey to enable the Edit mode. The 0.5key to enable the Edit mode. The 0.5 µµm & 5.0m & 5.0 µµm check boxm check box
will be highlighted.will be highlighted.
22 Press thePress theEnterEnterkey again to place a check mark in the check box.key again to place a check mark in the check box.
33
Advance to theAdvance to the 0.50.5µµmm& 5.0& 5.0µµmmTCP/IPTCP/IPcheck box and place a check mark in it.check box and place a check mark in it.
Figure H-1: Comm Setup, Network Dialog BoxFigure H-1: Comm Setup, Network Dialog Box
Figure H-2: Comm Setup, Data Dialog BoxFigure H-2: Comm Setup, Data Dialog Box