Statistics Mode OperationStatistics Mode Operation
LASAIR II Operator’s ManualLASAIR II Operator’s Manual
PagePage
8-138-13
55 Press Press the the green green Start Start button button on on the the control control panel. panel. The The pump pump begin begin toto
circulate air through the unit. After an initial delay circulate air through the unit. After an initial delay (to purge the sample path),(to purge the sample path),
the unit will begin sampling. The sampling process and the results of samplingthe unit will begin sampling. The sampling process and the results of sampling
can be observed on thecan be observed on theMain DisplayMain Display. When the sample is complete, the pump. When the sample is complete, the pump
stops.stops.
When Sample Acknowledge is ActivatedWhen Sample Acknowledge is Activated
If you have selectedIf you have selected Sample AcknowledgeSample Acknowledge, the following message will be, the following message will be
displayed:displayed:
Press thePress theEnterEnterkey to accept the sample or use the right arrow button to movekey to accept the sample or use the right arrow button to move
to “No” and then press the Enter key to reject the sample. to “No” and then press the Enter key to reject the sample. Rejected samples areRejected samples are
labelled as invalid and are not used in calculations. However, they are stilllabelled as invalid and are not used in calculations. However, they are still
stored in memory and printed on the stored in memory and printed on the final report.final report.
Figure 8-3: Main Display Screen when Statistics Mode is EnabledFigure 8-3: Main Display Screen when Statistics Mode is Enabled
Indicates that LASAIR IIIndicates that LASAIR II
is in statistics modeis in statistics mode
The location that will be sampled next.The location that will be sampled next.
To Next Page
Loading...
Need help?
General
