C CommandsC Commands
LASAIR II Operator’s ManualLASAIR II Operator’s Manual
PagePage
G-5G-5
63 63 Search Search Alarm Alarm Print Print On/OffOn/Off
C Command Table FormatC Command Table Format
These commands are from the C command above. All of these commands areThese commands are from the C command above. All of these commands are
redundant, and are provided for uredundant, and are provided for users of existing LASAIRs who want tosers of existing LASAIRs who want to
simplify their upgrade path. Some of these commands split internal variablessimplify their upgrade path. Some of these commands split internal variables
into several pieces. For instance “into several pieces. For instance “
C 0C 0
” through “” through “
C 6C 6
” are used to set date and” are used to set date and
time. Because of the variable split, unexpected results can be obtained if the usertime. Because of the variable split, unexpected results can be obtained if the user
is not careful with software coding. For instance, setting the is not careful with software coding. For instance, setting the date and time indate and time in
multiple parts has the multiple parts has the possibility of time-rollover in-between settings. In otherpossibility of time-rollover in-between settings. In other
words, if the LASAIR II seconds rolls over from 59 words, if the LASAIR II seconds rolls over from 59 to 0, then at a to 0, then at a minimum theminimum the
minutes will also change, and minutes will also change, and if this occurs right after setting the minutes, thenif this occurs right after setting the minutes, then
the expected time will be wrong.the expected time will be wrong.
Command FormatCommand Format
C nnC nnssssssssssssssssssssss
where:where:
C nnC nn= command # (0-38)= command # (0-38)
ssssssssssssssssssssss= any = any alphanumeric entry appropriate to the parameter beingalphanumeric entry appropriate to the parameter being
defined.defined.
To Next Page
Loading...
Need help?
General
