Name: Particle Measuring Systems LASAIR II 550L
Brand: Particle Measuring Systems
Rating: 4 (1 reviews)

To Next Page

To Previous Page



LLAASSAAIIR R III I OOppeerraattoorr’’s s MMaannuuaall PPaagge e LL--11

Appendix LAppendix L

HHIPAHHIPA

For users who prefer the beep mode For users who prefer the beep mode to be controlled at the probe, to be controlled at the probe, the Hand-Heldthe Hand-Held

Isokinetic Probe (Audible) (HHIPIsokinetic Probe (Audible) (HHIPA) is a sampling A) is a sampling probe with an probe with an LED activityLED activity

indicator and audible alarm.indicator and audible alarm.

The LASAIR HHIPA model is:The LASAIR HHIPA model is:

The HHIPThe HHIPA has a A has a thumbwheel selector switch which thumbwheel selector switch which determines how manydetermines how many

particles particles are rare required equired for for each each flash flash of of the Lthe LED iED indicator ndicator and beep and beep of of the the audibleaudible

buzzer.buzzer.

To set the selector switch:To set the selector switch:

If your instrument is the If your instrument is the LASAIR II, plug the LASAIR II, plug the DB connector from DB connector from the HHIPthe HHIPAA

into the LASAIR II’s HHIPA connector.into the LASAIR II’s HHIPA connector.

22 If you are using If you are using any other instrument, plug the any other instrument, plug the DB connector from the DB connector from the HHIPHHIPAA

into the AUX connector on the back panel of the counter.into the AUX connector on the back panel of the counter.

33 Connect the sample tube from the HHIPA to the particle counter's inlet jet.Connect the sample tube from the HHIPA to the particle counter's inlet jet.

The HHIPThe HHIPA functions oA functions off the LASAIR ff the LASAIR II’II’s first channel s first channel accumulative counts.accumulative counts.

44 Turn the instrument on and begin Turn the instrument on and begin sampling with the HHIPsampling with the HHIPA thumbwheel switchA thumbwheel switch

set to “0”.set to “0”.