Page Page 5-16 5-16 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Chapter 5: SetupChapter 5: Setup
22 Press Enter to activate Edit Mode.Press Enter to activate Edit Mode.
33 Tab to the firstTab to the first MinMinvalue field in the list. Use value field in the list. Use the directional arrow buttons onthe directional arrow buttons on
the control panel to move around the control panel to move around the list of variables.the list of variables.
44 PressPress EnterEnterto initiate the ability to change an alarm limit in a to initiate the ability to change an alarm limit in a Min or Max field.Min or Max field.
55
Use the editing icon softkeys and the up and down arrows to set or change theUse the editing icon softkeys and the up and down arrows to set or change the
alarm limit.alarm limit.
66 Press Enter to record that value and to move to the 1/0 radio button.Press Enter to record that value and to move to the 1/0 radio button.
77
Press Enter again to insert a bullet in the Press Enter again to insert a bullet in the 1/0 radio button. This alarm is now1/0 radio button. This alarm is now
enabled at the alarm limit you have selected.enabled at the alarm limit you have selected.
Printing Sampling and Alarm ParametersPrinting Sampling and Alarm Parameters
The current sampling setup and alarm settings can The current sampling setup and alarm settings can be printed from the Statusbe printed from the Status
Screen. Screen. From From the the main main display display screen, screen, select select the the button button to to get get to to the the StatusStatus
Screen. Screen. Then Then select select the the button button to to print print the the sampling sampling parameters.parameters.
Figure 5-9: Alarm Setup Screen, Analog Alarms PageFigure 5-9: Alarm Setup Screen, Analog Alarms Page
Analog Alarm Input AreaAnalog Alarm Input Area
To Next Page
Loading...
Need help?
General
