Paytec Eagle - Adjust Parameters in Fn00 (when MDB Unit is Connected)

17
Bills always
enabled ?
Bill Validator
ON in Ex-Ch ?
Coins enabled
with key-card ?
Adjust the following parameters in Fn00 (when an MDB unit is connected)
The parameters in Fn00 must be configured, otherwise the MDB Slave unit won’t be working correctly.
The system can be configured so that coins and bills are only accepted after inserting the key – no matter if the
validator is either an MDB Slave unit or a Paytec validator plugged on J9/J10.
N Coins are always accepted.
Y Coins are only accepted when a key/card has been inserted in the
cashless reader MDB.
The system can be configured to accept bills only if the key has been
inserted in the cashless reader connected.
N Bills are only accepted when a key/card has been inserted.
Y Bills are always accepted.
Attention
When NO cashless system has been installed, select “Y”
otherwise bills are not accepted.
N Bills are not accepted with Exact-Change condition.
Y Bills are also accepted with Exact-Change condition.