Paytec Eagle - Edit Machine Code from Keypad

76
Edit machine code from keypad
Starting from f/w revision 1.11 you can read and/or edit the machine code from keypad on changegiver.
At the same time press ESCROW LEVER + C,
The following message is displayed: CODE
Press F; the first half of the machine code is displayed.
The machine code (see Fn00) is made of 8 digits: xxxxyyyy .
The code is divided into 2 halves:
1
st
half: Hxxxx
2
nd
half: Lyyyy
The two halves of the code are alternatively displayed whenever pressing F
Press E more than once to increase the code or B to decrease it.
Keep E or B pressed to accelerate increase/decrease.
Press F to confirm the code set.
Press D to go back to the message CODE without saving the code set.
How to exit the procedure: press ESCROW LEVER + C, wait 30 seconds in idle state or switch the device OFF.