70
Unit Scaling
Factor EURO: 001
Number decimals
change (0-6) -
Number decimals
N.C.U.(0-4) -
Conversion date
dd/mm/yy
End N.C.U.
dd/mm/yy
Euro conversion
rate: ------
Fn38 – Euro parameters
DON’T edit parameters in this function for Euro-configured systems (currency description=978 in Fn00)
In NCU-configured systems (in countries that are planned to join the Euro area in the future), you can enter the
change rate that will be adopted when the system will be converted.
The EAGLE models distributed in the countries belonging to the Euro zone are already configured in Euro and
they will only accept Euro keys/coins. When a nonEuro key is inserted in a Euro-configured system, credit on that
key will be converted following the change rates in Fn38 (key type is also converted to “Euro key”).
Enter absolute value (cents included) without decimal point.
Enter the number of decimals on the absolute value.
Example: change rate: 1936.27
▼
Euro conversion rate=193627 and No. decimals change=2.
Decimal point position on the currency in use before Euro conversion.
Unit Scaling Factor after Euro conversion.
Default USF for EURO = 001.
Check compatibility between VM and USF.
Start conversion on a specified date.
Enter day / month / year.
The system will be automatically converted in Euro at midnight of the
specified date.
Leave “0” (zero) if you wish to inhibit this function.
Validity deadline for national currency (NCU, nonEuro).
The system will stop accepting money in national currencies from midnight
of the specified date.
From that date, EAGLE will start accepting Euro coins only.
Leave “0” (zero) if you don’t wish to enable this option.
In this case, when Euro conversion is started NCU coins are routed to the
cashbox and their value in converted in Euro (following the change rate
programmed).
To inhibit NCU coins, you need to manually set parameter “Inhibited? Y” in
Fn03 (with “P6000” or “Paytec Configurator”).
To Next Page
Loading...