44
Select
tube No. 1
Tube No. 1
No. coins 0
Tube No. 1
empty coins 10
Tube No. 1
max. coins 50
Fig.9
Tube group cover
Tube No. 1
FILL coins 0
Fn09 – Level in tubes
The parameters here below permit to set the max. level and empty level of coins in each tube.
The max. level depends on the thickness of the coin (do not exceed the default parameters set by Paytec).
When replacing a tube group, you need to adjust coin destination (Fn03) and the level of coins in each tube
(Fn09). If each tube can be replaced of the tube group, it is necessary to replace the label on the tube.
Select a tube: 1=A 2=B 3=C 4=D 5=E 6=F
The position of tubes is written on the label (Fig.9).
Tubes are identified with letters A-B-C-D-E-F.
No. coins in the tube selected (only-read parameter).
If you don’t have a P6000, you can read this value on the LCD (just click
the coin eject button quickly).
Empty level.
When this number has been reached, the tube is considered to be empty
(the system will no longer pay out that coin type).
Enter a value and press
.
Value recommended = 10
Do not enter a lower value than the one set by Paytec.
Max. number of coins in a tube.
Do NOT enter a higher value than the one set by Paytec. Enter a value for
each tube (enter value, then press
per confirm).
A tube is full when it contains the max. number of coins programmed here.
When this level has been reached, all the coins inserted fall in the cashbox.
As soon as the level lowers, coins fall into the tube again.
In FILL mode (manual filling), coins will fall in the tube until the FILL level
is reached (see next parameter)
Max. number of coins that can fall in the tube in FILL mode (when this
number is reached, any further coin is rejected).
Enter a value and press
to confirm.
Set a higher value than the EMPTY level, otherwise the Changegiver will
be in “Exact-Change” even after tubes have been filled.
If this value is left on “zero”, you can fill tubes in FILL mode up to the max.
number programmed.
During operation, the coins accepted fall in the tubes up to the max.
number for each tube is reached.
To Next Page
Loading...