Paytec Eagle - Fn27 - Conversion Keys

To Next Page

To Previous Page

Convert

Keys ?

Convert Type 1

in Type 98 ?

Old operator

Code -----

Old location

Code -----

Modify user

code? Y

Country code

(MDB) --

Fn26 – Country Code

Only for protocol MDB

Enter international phone code.

Fn27 – Conversion keys

“Conversion keys” is a special function permitting operators to re-encode Paytec keys from the key reader

connected.

Keys/cards Mifare

only permit operators to modify their format.

Modifiable parameters

▪ Key/card format: key1/card1 to key98/card98

▪ Operator code

▪ Location code

▪ User code

▪ Pin 1

▪ Pin 2

Whenever a key is inserted, the parameters in Fn06 are first checked. If a parameter is not correct, the same

parameter in Fn27 is also checked. When the two parameters are the same, the key is converted (the Led is

steady RED during conversion). Once the conversion sequence has been successfully completed, the Led is

GREEN and the key is ready for use.

Should an error occur during conversion, the Led is YELLOW and an error code is displayed (see table containing

error codes in user guide).

Parameters in Fn27

Y Key codes can be modified.

Y Key format can be modified.

Enter old operator code.

Enter old location code.

Y User code can be modified.