Paytec Eagle - Fn05 - Bill Values

35
1^ Bill
Value 5,00
2^ Bill
Value 10,00
3^ Bill
Value 20,00
Fn05 – Bill values
Enter bill values when a bill validator in parallel mode has been connected.
When a bill validator MDB has been connected, you don’t have to enter bill values (bills are controlled via protocol
MDB).
Enter the 1
st
bill values accepted (e.g. €5.00) and press  to confirm.
Enter the 2
nd
bill values accepted (e.g. €10.00) and press  to confirm.
Enter the 3
rd
bill values accepted (e.g. €10.00) and press  to confirm.
Some bill validators can work in “pulse” mode (the number of pulses transmitted to the output is proportional to
the USF programmed).
In this case, when setting bill no.1 its value must be the same as the USF programmed (read user guide of the
bill validator).
For PAYTEC bill validator in pulse mode the USF is € 5.00.
Bill validator models and logic level INH are set in Fn00.
Consult the bill validator user guide (on some models, you can modify configuration depending on the operating
mode selected).