Pentair FLECK 5800 SXT - Diagnostic mode; LXT controller; Basic programming

Installer Manual Fleck 5800 - SXT - Safety
10 / 92 Ref. MKT-IM-004 / A - 18.04.2017
2. Safety
2.1. Safety pictograms definition
2.2. Safety tags location
Note
Ensure that the safety tags on the device are completely legible and clean. If necessary,
replace them with new tags and put them in the same places.
2.3. Hazards
All the safety and protection instructions contained in this document must be observed in order to
avoid temporary or permanent injury, damage to property or environmental pollution.
At the same time, any other legal regulations, accident prevention and environmental protection
measures, as well as any recognized technical regulations relating to appropriate and risk-free
methods of working which apply in the country and place of use of the device must be adhered to.
Any non-observation of the safety and protection rules, as well as any existing legal and technical
regulations, will result in a risk of temporary or permanent injury, damage to property or
environmental pollution.
Caution
Warns of a risk of minor injury or major
material damage to the device or
environment.
Warning
Warns against serious personal injury
and damage to health.
Danger
Warns against serious personal injury or
death.
Mandatory
Standard or measure to apply.
Note
Comment
Prohibition
Restriction to be observed.
Valve type
Serial number
BLFC flow rate
Piston type
DLFC flow rate
Injector size