Pentair FLECK 5800 SXT - Replacing the Controller Motor

Installer Manual Fleck 5800 - SXT - Maintenance
Ref. MKT-IM-004 / A - 18.04.2017 71 / 92
9.2.3. Replacing the controller motor
No. Operation
A Remove the controller, see 9.2.2. Replacing the controller, page 70.
B Disconnect the optical sensor (3).
C Disconnect the motor.
D Open the motor clips (1) and pull out the old motor (2).
E Change the motor (2).
F Reverse above procedure steps to rebuild.