Pentair FLECK 5800 SXT - Flow Based Relay Setting (VR)

Installer Manual Fleck 5800 - SXT - Programming
Ref. MKT-IM-004 / A - 18.04.2017 59 / 92
6.5.18.1 Relay start time (ST)
Set the relay start time.
Note
This option is available only if RE is set to tb.
Note
The relay start time can be set from 0 minute to the total of time of all the cycles minus 1
minute.
6.5.18.2 Relay end time (ET)
Set the relay end time.
Note
This option is available only if RE is set to tb.
Note
The relay end time can be set from start time to the total of time of all the cycles.
6.5.19. Flow based relay setting (VR)
Select the relay setting.
Note
The relay can bet set upon a time base (tb) or a flow base (Fb). Only one method can be used
at a time.
Note
This option is available only if RE is set to OFF.
Note
If set to Fb, the controller will enable and disabled the relay output every time the set volume
interval is reached for the set time ON.
AX Press or to set the relay start time.
AY Press to validate the selection and move to the next parameter.
AZ Press or to set the relay end time.
BA Press to validate the selection and move to the next parameter.
BB Press or to select between Fb and OFF.
BC Press to validate the selection and move to the next parameter.