Pentair FLECK 5800 SXT - Days Override (DO)

Installer Manual Fleck 5800 - SXT - Programming
Ref. MKT-IM-004 / A - 18.04.2017 55 / 92
6.5.10.2 Fixed reserve capacity (RC)
Set the reserve capacity.
Note
The fixed reserve capacity parameter is only available if this option has been set in reserve
selection.
Note
The fixed reserve capacity is a fixed volume and does not change if the unit capacity or
feedwater hardness are changed.
Note
The fixed reserve capacity can be set up to a volume equivalent to 50% of the initial
volumetric capacity.
6.5.11. Days override (DO)
Set the maximum number of days between regeneration cycles.
Note
This parameter allows to set the maximum amount of days that the system can stay in
service mode without a regeneration.
Mandatory
In time clock mode the setting of this parameter is mandatory and the electronic will need
at least one regeneration day activated.
Note
Setting the parameter to "OFF" disables this function.
Note
The number of days can be set from OFF, or 1 to 99 days.
U Press or to set the safety factor.
V Press to validate the selection and move to the next parameter.
W Press or to set the reserve capacity.
X Press to validate the selection and move to the next parameter.
Y Press or to set the days override.
Z Press to validate the selection and move to the next parameter.