Pentair FLECK 5800 SXT - Resetting the Controller; Soft Reset (SR); Hard Reset (HR)

Installer Manual Fleck 5800 - SXT - Programming
Ref. MKT-IM-004 / A - 18.04.2017 63 / 92
6.8. Resetting the controller
Note
There are two methods to reset.
6.8.1. Soft reset (SR)
Caution
All the parameters are set to default values, except volume remaining in volumetric
systems and days since last regeneration in time clock systems.
6.8.2. Hard reset (HR)
Caution
All the parameters are set to default values.
A Press and hold and for 25 seconds while in normal service mode
until SR is displayed.
A Hold while powering up the unit.
B The display shows HR.
C Reprogram all parameters in Master programming mode.