Pentair FLECK 5800 SXT - Replacing the Optical Sensor

Installer Manual Fleck 5800 - SXT - Maintenance
76 / 92 Ref. MKT-IM-004 / A - 18.04.2017
9.2.8. Replacing the optical sensor
No. Operation
A Remove the controller, see 9.2.2. Replacing the controller, page 70.
B Disconnect the wire from the motor to the optical sensor (4).
C Release the optical sensor support (1) by pushing it back and up as shown.
D Release the optical sensor (3) from its support (1) by pressing the clips (2).
E Change the optical sensor (3).
F Reverse above procedure steps to rebuild.