Installer Manual Fleck 5800 - SXT - Programming
Ref. MKT-IM-004 / A - 18.04.2017 47 / 92
6.2. Commands
6.3. Setting the time of the day (TD)
Set the time in the system.
6.4. Basic programming
Note
Menus are displayed in a defined and incremental order.
6.4.1. Day of Override (DO)
Determine the maximum number of days of operation without regeneration.
2. Data display
3. PM indicator → Appears if controller set in US unit.
4. Flow indicator → Flashes when outlet flow is detected.
5. x1000 indicator → Appears when the displayed number is bigger than 9999.
6. Programming icon → Appears in programming modes.
7. Service icon → Appears in service mode;
→ Flashes if a regeneration cycle has been queued.
8. Error /
Information icon
→ Appears in case of error, see page 75, or in diagnostic mode, see
page 61.
A Press to pass to the next step.
B Use and to adjust the values.
A Press and hold or until the programming icon replaces the service
icon and the parameter display reads TD.
B Set the time with or .
C Press to validate the selection and return to the service mode, or wait
for 10 seconds.
A Press and simultaneously for 5 seconds to enter the menus
sequence.
B Select the number of days of Override with and .
C Press to validate the selection and advance to the next parameter.
To Next Page
Loading...
