Installer Manual Fleck 5800 - SXT - Programming
Ref. MKT-IM-004 / A - 18.04.2017 57 / 92
6.5.13.3 For regeneration type O-UF and O-DF
Note
The regeneration cycles are identified as C1 to C20.
Mandatory
The last cycle must be set with LC.
6.5.14. Day of week (Dn, n = 1 to 7)
Set the day of week for regeneration.
Note
The day of week parameter is only available if time clock week mode has been set in
controller type selection.
Note
By default, every Dn is set to OFF.
6.5.15. Current day (CD)
Set the current day.
Note
The current day is defined from D1(Monday) to D7 (Sunday).
AE Press or to set the type of regeneration cycle.
AF Press to validate the selection.
AG Press or to set the regeneration time of this cycle.
AH Press to validate the selection and move to the next regeneration
cycle.
AI Repeat Z to AC as needed.
AJ Select LC.
AK Press to validate the selection and to move to the next parameter.
In this example:
C1 = Rapid Rinse
for 30 min
AL Press or to set "ON" or "OFF" to set the day as a regeneration day.
AM Press to validate the selection.
AN Repeat AE to AF until D7 is set.
AO Press to validate the selection and move to the next parameter.
AP Press or to set the current day.
AQ Press to validate the selection and move to the next parameter.
To Next Page
Loading...
