2
• Do not place your finger over the flash when discharging the flash. You may burn
yourself.
• Do not cover the flash with clothing when discharging the flash. Discoloration may
occur.
• Do not send data via infrared transmission with the infrared port of the camera pointed
at a person’s eyes. Doing so may cause impaired eyesight and other injury.
• Some portions of the camera heat up during use. There is a risk of low temperature
burns when holding such portions for long periods.
• Should the monitor be damaged, be careful of glass fragments. Also, be careful not
to allow the liquid crystal to get on your skin or in your eyes or mouth.
• Depending on your individual factors or physical condition, the use of the camera may
cause itching, rashes or blisters. In case of any abnormality, stop using the camera
and get medical attention immediately.
Warning
• Always use the battery charger and AC adapter exclusively developed for this
product, with the specified power and voltage. Using a battery charger or AC adapter
not exclusive to this product, or using the exclusive battery charger or AC adapter with
an unspecified power or voltage can cause a fire, electric shock, or camera
breakdown. The specified voltage is 100 - 240V AC.
• Do not disassemble or modify the product. This can cause a fire or electrical shock.
• If the generation of smoke or strange odor from the product or other abnormality
occurs, immediately discontinue using and consult a PENTAX Service Center.
Continuing to use the product can cause a fire or electrical shock.
• If water should happen to get inside the product, consult a PENTAX Service Center.
Continuing to use the product can cause a fire or electrical shock.
• If thunderstorm should be present during use of the battery charger and AC plug cord,
unplug the power plug and discontinue use. Continuing to use the product can cause
damage to the equipment, fire or electrical shock.
• Wipe off the power plug if it should become covered with dust. Accumulated dust may
cause a fire.
• To reduce the risk of hazards, use only CSA/UL certified power supply cord set, cord
is Type SPT-2 or heavier, minimum NO.18 AWG copper, one end with a molded-on
male attachment plug cap (with a specified NEMA configuration), and the other is
provided with a molded-on female connector body (with a specified IEC nonindustrial
type configuration) or the equivalent.
Caution
• Do not place or drop heavy objects on or forcefully bend the AC plug cord. Doing so
may damage the cord. Should the AC plug cord be damaged, consult a PENTAX
Service Center.
• Do not touch or short-circuit the terminal area of the AC plug cord while the cord is
plugged in.
• Do not handle the power plug with wet hands. This can cause an electric shock.
• Do not drop the product, or subject it to violent impact. This can cause equipment
breakdown.
• Do not use the battery charger to charge batteries other than the rechargeable
lithium-ion battery D-LI109. Attempting to charge other types of batteries may cause
an explosion or heating, or may damage the battery charger.
About the Battery Charger and AC Adapter
To Next Page
Loading...
Need help?
General
Weight and Dimensions
