99
Shooting Functions
4
Metering is weighted at the center of the screen.
Use this metering when you want to compensate
the exposure by experience, instead of leaving it
to the camera. The illustration shows that
sensitivity increases as the pattern height
increases (center). This mode does not
automatically compensate for backlit scenes.
With spot metering, brightness is measured
only within a limited area at the center of the
screen as shown in the illustration. You can
use this in combination with the AE lock
(p.102) when the subject is extremely small
and proper exposure is difficult to obtain.
Using the Center-Weighted Metering
Using the Spot Metering
Linking AF Point and AE During Multi-Segment
Metering
In [7. Link AF Point and AE] (p.73) of the [A Custom Setting] menu,
you can link the exposure and AF point in the focusing area during
multi-segment metering. The default setting is [Off].
1
Off Exposure is set separately from AF point.
2
On Exposure is set in accordance with AF point.
Setting the Meter Operating Time
Sets the exposure metering time in [5. Meter Operating Time] (p.73)
in the [A Custom Setting] menu. The default setting is [10 sec].
1
10 sec Sets exposure metering timer to 10 seconds.
2
3 sec Sets exposure metering timer to 3 seconds.
3
30 sec Sets exposure metering timer to 30 seconds.
Downloaded From camera-usermanual.com Pentax Manuals
To Next Page
Loading...
Need help?
General
