118
Shooting Functions
4
4
Press the four-way controller (3) and use the four-way
controller (45) to select g or h.
5
Press the 4 button.
The camera is ready to take pictures continuously.
6
Press the shutter release button halfway.
The autofocus system operates. The focus indicator ] appears in the
viewfinder when focused.
7
Press the shutter release button fully.
Pictures are taken continuously while the shutter release button is fully
pressed. Take your finger off the shutter release button to stop.
• If the focus mode is set to l (Single mode), the focus position is locked
on the first frame and pictures are taken continuously at the same interval.
• Focusing is continuously active during continuous shooting when the focus
mode is set to k (Continuous mode).
• The shutter cannot be released until charging is complete when using the
built-in flash. You can set the camera to enable shutter release before the
built-in flash is ready in the [A Custom Setting] menu. (p.137)
• You can also use the remote control for continuous shooting. (p.125)
• Select a setting other than gh in the Drive Mode options screen to cancel
continuous shooting. The setting is canceled when the camera is turned off if
[Drive Mode] in [Memory] of the [A Rec. Mode] menu (p.236) is set to P
(Off).
Downloaded From camera-usermanual.com Pentax Manuals
To Next Page
Loading...
