3. Magnetic sensor (for kart)
1. Use two-sided tape to attach the sensor on the floor panel. Attach so that the front of
the sensor points in the direction of forward travel. (Refer to the installation drawing.)
If you want to fasten the sensor securely in place, use M4 screws, tying bands, or
covering the sensor by vinyl tape. * The M4 screws and tying bands are not provided.
2. The sensor should be a minimum of 5 cm from any metal of main frame.
3. Connect the magnetic sensor connector to the LAP sensor port on the control unit.
At this time, verify that the power switch is off. If the power switch is on, the lap count
may start automatically, however this is not an error. Press the CLEAR key to stop
the count.
CAUTION: Position the sensor as far as possible from the ignition coil, plug cords, or
other items which generate a magnetic field.
Adjust the cables so that they do not contact the pulse lead.
-11-
<Sensitive Magnetic sensor (for 2 wheels or 4 wheels)>
１． Use two-sided tape to attach the sensor to the non-metallic part of the car body.
Attach so that the front of the sensor points in the direction of forward travel. If you
want to fasten the sensor securely in place, use M4 screws, tying bands, or
covering the sensor by vinyl tape. * The M4 screws and tying bands are not
provided.
２．
Install the sensor so that the height above the ground is 15 cm or less. The sensor
sensitivity varies depending on the type of magnets installed under the course. We
recommend to install the sensor as closer as possible to the ground without
interfering with safety mechanism on the vehicle.
３． Connect the magnetic sensor connector to the LAP sensor port on the control unit.
At this time, verify that the power switch is off. If the power switch is on, the lap
count may start automatically, however this is not an error. Press the CLEAR key
to stop the count.
Front or back
M4screw
Tie band
To Next Page
Loading...