-40-
No. 16: Gear position
* Press the CLEAR key and display parameter No. 16.
16－－－: No gear display
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter a hyphen.
２． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
16－－1: Calculate the gear ratios.
If no information is available concerning the gear ratio for the vehicle, this calculates
the final reduction gear ratio for each gear No. during actual vehicle driving.
※ Take the speed signal from a drive-side wheel so that the display will be correct.
１． There is a flashing hyphen or number on the right side of parameter No. 16.
Press the SET key and enter 1.
２．
Press the SHIFT key and move the flashing part to the total number of gears
display. Press the SET key and enter the total number of gears.
３．
Press the SHIFT key and move the flashing part to the tolerance display. Press
the SET key and enter value. * Begin from 3%.
４．
Press the SHIFT key and move the flashing part to the pulse number display.
Press the SET key and enter the pulse count.
５．
Press the SHIFT key and move the flashing part to the gear No. display. Actually
drive the vehicle. Press the SET key and enter "1" for the 1st gear No., then
press and hold the SET key until the TEACH indicator turns on. The unit begins
calculating. After some time, when the TEACH indicator turns off and a value
appears in the gear ratio display, teaching is completed.
To Next Page
Loading...