(for 2 wheels or 4 wheels)
Tie band
-12-
Sensing span
150 mm
or less
M4 screw
* It is possible to reverse the sensor.
Front or back
<Example of installation onto a minibike>
In the above photo, the sensor is installed horizontally
inside the under cowling of the motorcycle. * The photo
shows the under cowling opened.
4. Pulse lead for RPM
1. For Kart engines, replace the spark plug cap with a noise-suppressing product
(NGK LB05EMH or equivalent) or use a resistor spark plug.
2. Clip the lead to where RPM is correctly measured such as where all the plug leads
are gathered or the ignition coil lead.
3. Insert the pulse lead connector into the REV jack of the control unit.
CAUTION: The RPM pulse lead has not been soldered to the clip to help dampen
large engine ignition pulses that may enter the microcomputer of the control unit from
the RPM pulse lead. Direct connection will cause damage to the unit, ensure there is
no electrical contact between the cable and clip.
To Next Page
Loading...