Percul Lapcom S Separate 100 - Parameter Configuration Guide

7) Setting of Parameters
<Changing the main unit to the parameter setting screen>
１． Verify that [READY] is displayed on the display screen. If [READY] is not
displayed, press the CLEAR key to display it.
２． Press and hold the SHIFT key and MODE key at the same time for 3 seconds to
change to the parameter setting screen. The parameter number is displayed at
the top left of the display.
３． Press the CLEAR key and set each parameter from No. 0 – 19 in sequence.
Press the MODE key to check the parameter No. settings in descending order.
４．
When the CLEAR key is pressed and held for 3 seconds, the settings will be
saved, the screen returns to the initial screen and [READY] is displayed.
READY
SHIFT
キ
ー
MODE
キ
ー
＋
3 seconds
To the parameter setting
Parameter No.
SHIFT
キ
ー SET
キ
ー
SHIFT key
MODE key
SHIFT key
MODE key
SHIFT
キ
ー
SET key
CLEAR key
Primarily used to
change the flashing
location or digits.
Primarily used to ente
r
and select numbers.
Confirms the settings
and moves to the
next setting screen.
A
llows the settings
to be checked or se
t
in descending order.
Displays the current setting.
-19-