No. 1: Hour meter, trip meter, and odometer
Hour, trip, and odometer data can be recorded and displayed for a maximum of 5 types
of engines or vehicles.
* Press the CLEAR key and display parameter No. 1.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter the number of vehicle or engines to register. If the
displays will not be managed for different vehicles or engines, set a hyphen.
２． To reset the trip meter, odometer, and hour meter to zero, select on the display
the registered No. that you want to reset on the screen and press and hold the
SHIFT key for 3 seconds.
* On the “01---“ display screen, it is possible to reset the only trip meter to zero.
３． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
* The hour meter does not count up when RPM is not being measured.
* The odometer and trip meter do not count up when wheel speed is not being
measured.
Hour meter Odometer
Paramete
To Next Page
Loading...