Percul Lapcom S Separate 100 - No.3: Number of Segments

No. 3: Number of Segments
First, set the total number of beacons installed in the course. Next, enter the No. of the
first beacon that will be detected after leaving the pit.
* Press the CLEAR key and display parameter No. 3.
１． The total number of beacons in the course flashes. Press the SET key and enter
the number.
２． Press the SHIFT key to move the flashing part to the right. Then press the set
key and enter the number of the first beacon that will be detected.
３． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Parameter No.
Total number of installed
beacons
No. of the beacon first detected
after entering the course
[Setting the No. of the first detected beacon]
If the lap measurement beacon is No. 1, then the course beacon which is first detected
after the vehicle leaves the pit is the No. 2 beacon for measuring the No. 2. section.
Pit
No.1 la
p
beacon
Se
g
ment 1
Se
g
ment 2
Se
g
ment 3
No.2 beacon
No.3 beacon
* If only 1 beacon is installed in the course, set "1 – 1".
-23-
* If section times will not be measured, set "1 – 1".